Craftsman 247.88705 Manual Del Operador página 11

aUger ControL
Located on the upper handle, the auger control handle is used to
engage and disengage drive to the auger. Squeeze the control handle
against the upper handle to engage the auger; release it to disengage.
CHUte assembLy
Rotate the discharge chute to the left or right using the chute handle.
The pitch of the discharge chute controls the angle at which the snow
is thrown. Loosen the wing knob on the side of the discharge chute
before pivoting the discharge chute upward or downward. Retighten
the knob once the desired position has been achieved.
sHaVe PLate
The shave plate maintains contact with the pavement as the snow
thrower is propelled, allowing snow close to the pavement's surface to
be discharged.
eLeCtriC starter oUtLet
The electric starter outlet requires the use of a three-prong outdoor
extension cord and a 120V power source/wall outlet.
NOTE: The electric starter is mounted to the plastic shroud and is
shown in Figure 7 attached to the engine for easier reference.
eLeCtriC starter bUtton
Pressing the electric starter button engages the engine's electric
starter when plugged into a 120V power source.
OPERATION
before starting tHe engine
Read, understand and follow all the instructions and warnings on the
machine and in this manual before operating.
1. The spark plug wire was disconnected for safety. Attach the spark plug
wire to the spark plug before starting.
starting tHe engine
Always keep hands and feet clear of moving parts. Do not use a
pressurized starting fluid. Vapors are flammable.
To avoid carbon monoxide poisoning, make sure the engine is
outdoors in a well-ventilated area.
NOTE: Allow the engine to warm up for a few minutes after starting.
The engine will not develop full power until it reaches operating
temperatures.
electric starter
The electric starter is equipped with a grounded three-wire power
cord and plug, and is designed to operate on 120 volt AC household
current. It must be used with a properly grounded three-prong
receptacle at all times to avoid the possibility of electric shock. Follow
all instructions carefully prior to operating the electric starter. DO NOT
use electric starter in rain.
1. Determine that your home's wiring is a three-wire grounded system.
Ask a licensed electrician if you are unsure. If you have a
grounded three-prong receptacle, proceed as follows. If you do
not have the proper house wiring, DO NOT use the electric starter
under any conditions.
2. Insert the ignition key fully into the slot, Figure 8. Make sure it
snaps into place. DO NOT turn the ignition key, doing so might
cause it to break. The engine cannot start unless the key is
inserted into the ignition switch.
11
Warning
Warning
Warning
Warning
Figure 8