Descargar Imprimir esta página

Siefken SCHOCK DAMON SDS MAX 1.700w Instrucciones De Uso página 25

Publicidad

Idiomas disponibles

Idiomas disponibles

Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
NOTE : When using tools such as Tine chisel, drill bits, etc., make sure to use the genuine parts
designated by our company.
(1) Clean the bit shank and apply grease before inserting the bit.
(2) Insert the bit into the tool. Turn the bit with slight pressure, you can feel a spot where there is
a hitch. At that spot, push it in until engages in.
(3) Pull the bit to make sure it is locked completely.
(4) To remove the bit, fully pull the ex sheath in the direction of the arrow and pull out the tool.
2. Auxiliary handle (Fig.2)
Operate your power tool only with the auxiliary handle.
The auxiliary handle can be set to any position for a secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle in counterclockwise direction and swivel the auxi-
liary handle to the desired position. Then retighten the bottom part of the auxiliary handle by
turning in clockwise direction.
Pay attention that the band of the auxiliary handle is positioned on the front housing as inten-
ded for.
3. Regulating the number of rotations and hammering (Fig. 3)
This Rotary Hammer is equipped with a built-in electronic control circuit that can adjust and
regulate the number of rotations and times of hammering. This Rotary Hammer can be used by
adjusting the speed adjuster knob, depending upon the contents of operation, such as boring
holes into fragile materials, chipping, centering, etc.
The scale'1' of the speed adjuster knob is designed for a minimum speed with the number of 100
rotations per minute and 1.750 times of blow per minute. The scale '6' is designed for a maximum
speed with the number of 220 rotations per minute and 2.150 times of blow per minute.
CAUTION: Do not adjust the speed adjuster knob during operation. Doing so can result in injury
because the Rotary Hammer must be held by only one hand, disabling the steady control of the
Rotary Hammer.
8

Publicidad

Capítulos

loading

Este manual también es adecuado para:

Sd5519