cecotec HidroBoost 1400 Manual De Instrucciones página 22

ENGLISH
NOTE: Pay special attention when cleaning delicate surfaces such as bodywork o wheel rims,
lacquered surfaces, wood, paint, etc.
SPRAY MODE
Turn the pulverizing nozzle to select the flat-fan pattern. A
wide stream will distribute the impact of water over a larger
area, resulting in excellent cleaning action with a reduced
risk of surface damage. Large surface areas can be cleaned
more quickly using a wider stream.
PRODUCT OPERATION
NOTE: The motor on this pressure washer does not run continuously. It only runs when the
trigger of the spray gun is squeezed. After following the start-up procedures in this manual,
turn the pressure washer on and squeeze the trigger for activation.
NOZZLE CLEANING
A clogged or partially clogged nozzle can cause a significant reduction of water coming out of
the nozzle and cause the unit to pulsate while spraying. To clean out the nozzle:
• Turn off and unplug the unit.
• Turn off water supply. Relieve any pressure trapped in the high-pressure hose by
squeezing the trigger 2-3 times.
• Separate the lance from the gun.
• Rotate the nozzle to the narrow stream setting. This activates the fan blades.
• Use the cleaning kit provided, or any other type of pointed element such as an unfolded
paper clip to clean the nozzle. Insert the wire into the nozzle hole and move back and
forth until debris is dislodged. (See Figure 2).
• Remove debris by back-flushing water through the nozzle. To do this, point the end of a
garden hose (with water running) to the nozzle's end for 30-60 seconds.
ANGLE FROM THE HIGH-PRESSURE HOSE TO THE CLEANING SURFACE
When spraying water against a surface, maximum impact is reached when the water strikes
the surface head on. However, this type of impact tends to cause dirt particles to imbed in the
22 HIDROBOOST 1400
Fig. 2