Change To The Edging Mode; Adjust The Cutting Diameter - GreenWorks STG309 Manual Del Operador

7
9.5

CHANGE TO THE EDGING MODE

The machine can be used in combination with the edge
guide for edging sidewalks and walkways.
1. Stop the machine and flip down the edge guide from
stored position.
2. Push the lock button (12) and turn the lower shaft 90° or
180° until it engages.
3. Release the lock button.
12
NOTE
English
9.6 ADJUST THE CUTTING
DIAMETER
The machine is set at a 9 in. (228 mm) cutting diameter.
You can adjust to a 11 in. (280 mm) cutting diameter.
Set the cutting diameter to 9 in. (228 mm) for greater
runtime and 11 in. (280 mm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade (16).
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
9
NOTE
16
EN