Troubleshooting - Pfannenberg DTS Serie Manual De Instrucciones

GB
6

Troubleshooting

Fault
Unit does not cool;
Evaporator fan
(internal) running
Unit does not cool
sufficiently
Condensate
accumulates in the
switch cabinet
Condensate does not
drain
Condensate drains from
the unit

The blinking of the red LED light on the controller circuit board is not a fault indicator or error message. The red
LED light indicates that voltage is supplied to the cooling unit.
Operating Manual DTS and DTI 6X2E Premium Controller X-Series (XC) 086100099d © Pfannenberg GmbH
Possible causes
• Temperature setting too high.
• Operating limits exceeded.
• Too little coolant.
• Heat exchanger dirty.
• Evaporator fan (internal) defect.
• Condenser fan (external) defect.
• Disturbance in the air circulation
inside the cabinet.
• Exhaust temperature is too high.
• Switch cabinet is not sufficiently
sealed.
• Condensate drain is plugged up.
• Condensate evaporator defector is
too much condensate accumulates.
• Switch cabinet is not sufficiently
sealed.
Corrective measures
 Check the temperature setting.
 Check the ambient temperature and internal
load.
 Call in authorized qualified personnel to
check the unit for leakage.
 Clean the heat exchanger.
 Call in authorized, qualified personnel;
replace fan.
 Check the installation and the path of air
circulating in the switchgear cabinet.
 Check the supply and outlet flow of air of
the cooling unit to the inlet and outlet
opening of the switch cabinet.
 Close the cabinet door.
 Correct leaky points or seals on the switch
cabinet.
 Check the temperature setting.
 Clean the condensate drain.
 Check whether the condensate drain hose
is free from kinks and is installed with a
downward slope.
 Correct leaky points or seals on the switch
cabinet.
Page 40 / 42