Apply Sealant To The Door - Kohler K-1000-H2 Manual Del Usuario

26. Apply Sealant to the Door

IMPORTANT! Apply silicone sealant to the outside bottom edge of the center jambs, side panels, and wall
jambs only. On the inside, apply a bead of silicone sealant vertically along the seam between the wall
jambs and finished wall surface. Do not apply sealant to the inside of the side panels.
NOTE: Door seals are an integral part of this door. However, sealing with a quality clear silicone sealant is
necessary to ensure a properly functioning, watertight unit.
Mask both edges of the joint to be sealed. Maintain a joint width of 1/8" (3 mm) to 3/16" (5 mm).
Apply a uniform bead of sealant.
Smooth the bead with your finger.
Remove the tape from the sealed joints immediately after smoothing the bead.
Repeat for all areas to be sealed.
Kohler Co.
Seal
Inside Unit
Masking
Seal Locations
Tape
23
1/8" (3 mm) to
3/16" (5 mm)
Footbath
1032108-2-D