Prepare The Site - Kohler K-6880 Guía De Instalación Y Cuidado

1.

Prepare the Site

Hanger
Étrier de support
Soporte de suspensión
Mounting Holes
Orifices de fixation
Orificios de fijación
Mark mounting holes.
Marquer les orifices de fixation.
Marque los orificios de fijación.
Backing
Renfort
Refuerzo
Install hanger bolts.
Installer les boulons d'ancrage.
Instale los pernos de sujeción.
IMPORTANT! The lavatory basin must be supported by the console table.
Install sufficient backing behind the finished wall to provide adequate support to
secure the mounting hardware.
Install the water supplies and drain piping according to the roughing-in
information. Ensure the supply stop handles will not make contact with the
console table when the supplies are fully open.
Using lag bolts (not provided), secure the hanger to the finished wall. Refer to the
roughing-in dimensions for proper placement of the hanger.
CAUTION: Risk of personal injury or product damage. Product can break, chip,
or cause injury if handled carelessly. The lavatory basin is not secured; have
someone hold the basin while you mark the mounting hole locations.
With assistance, lift the lavatory basin onto the hanger. Verify the lavatory basin is
properly placed and is level.
Mark the two mounting holes on the finished wall.
Carefully remove the lavatory basin from the hanger.
Using a 1/4" drill bit, drill at the marked mounting holes.
Temporarily thread a cap nut (provided) onto each threaded stud (provided).
Using an adjustable wrench, install the threaded studs into the anchoring holes.
Approximately 1-3/8" (3.5 cm) of the threaded stud must protrude from the
finished wall.
Remove and retain the cap nuts.
1007272-2-B
Install backing.
Installer de renfort.
Instale del refuerzo.
Finished Wall
Mur fini
Pared acabada
Hanger Bolt
Boulon d'ancrage
1-3/8"
Perno de sujeción
(3.5 cm)
6 Kohler Co.