Steamfast SF-142 Guia Del Usuario página 3

10. Do not use unit where aerosol-based products are being used, or where oxygen is being
administered.
11. Unit is only meant to be used with recommended Steam Mop model SF-142 accessories.
Using other types of attachments may cause damage to unit or injury.
12. If red Power Indicator Light does not illuminate when unit is plugged in and On/Off Switch is
pressed, unit is not operating normally. Immediately disconnect cord from power supply, then
refer to troubleshooting guide on Page 12 of this manual for assistance.
13. Always turn unit off and unplug power cord before filling Boiler with water. Do not attempt to
use unit without properly filling Boiler.
14. When filling Boiler, only water should be used in unit – other cleaning agents could damage
unit or cause injury. Distilled or de-mineralized water is highly recommended, in order to
minimize potential build-up of mineral deposits. Do not overfill unit.
15. To reduce risk of contact with hot water emitting from Steam Nozzles, check appliance before
each use by positioning it away from body and turning it on. Do not operate unit if Steam
Nozzles are blocked.
16. Burns can occur from touching hot metal parts, hot water, or steam. Do not touch bottom of
Mop Head or attempt to attach a Microfiber Pad by hand while unit is in use. Use caution
when you turn unit upside-down – there may be hot water in Boiler.
17. Use caution when using unit on uneven surfaces, such as stairs.
18. When steaming any surface for the first time, it is recommended that you consult the
manufacturer's guidelines for material being steamed. For items in question, test on an
inconspicuous area before proceeding.
19. Steaming unsealed hardwood or unglazed ceramic surfaces is not recommended, and may
result in warping or damage to the surface. Steam may remove the sheen from surfaces
treated with wax.
20. When steam mopping, never leave unit resting in one spot on any surface for any period of
time – prolonged exposure to heat and moisture may damage floor surfaces.
21. Do not allow power cord to touch hot surfaces during use. Wrap cord loosely around Cord
Brackets when storing.
22. Always allow Steam Mop to cool (at least 30 minutes for complete cooling) and empty Boiler
before storing. Do not store unit with a damp Microfiber Pad still attached.
SAVE THESE INSTRUCTIONS!
FOR HOUSEHOLD USE ONLY
Questions or comments?
•
www.steamfast.com
•
consumerservice@steamfast.com
•
1-800-711-6617
ENGLISH | 3