Publicidad
Idiomas disponibles
Idiomas disponibles
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the positions of the objects in the rack are
correct.
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into the
suitable container minding not to cram them and
with
handgrips
towards
drawing).
SALT CONTROL
(for machines with Water softener)
If the glass-washer is equipped with a Water
softener the
regeneration of resins is
automatic according to parameters fixed by the
producer.
According to the water hardness, it is possibile to
modify the programming of the regeneration.
See the corresponding table in the installer section.
When it is necessary to add salt in the container, t
green lamp "H" lights up
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
Attention!
The lack of salt in the container damages the
machine
because
of
defective washing of glasses and dishes.
These damages are not covered by the warranty.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier will be able to
suggest
the
most
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/lt.
the
bottom
(see
.
limestone,
besides
suitable
product.
Your
CLEANSING AGENTS
Choice of the suitable cleansing agent is an
essential condition if you want to obtain
extremely good washing results as regards
hygienic results. It is then important to consider
some points. First of all only highly alkaline and
chlorine-active antifoam products, especially
made for industrial dish-washing machines,
must be used and they must be produced by
well-known reliable Firms. Mean concentration
of the cleansing agents in powder must be
1,5÷2,5 g/lt. Mean concentration of liquid
cleansing agents must be 2÷4 g/lt.
In order to avoid scales and corrosions, put the
cleansing agent above water level on the
nearest area of the sucking pump filter, in this
way it will immediately dilute and will not deposit
on the tank bottom.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3
Afterwards push button "P" for 3 seconds.
(the lamp "H" is lighted).
he
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph "Daily maintenance" on
page 23)
a
22
Publicidad
