Installation Procedure; Prepare Installation Space; Install Appliance - Gaggenau VK 230 714 Instrucciones De Instalación

Installation Procedure

Prepare Installation Space

Create the cut-out in the countertop for one or several
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
Observe minimum distance between appliance
underside and furniture parts of
When installing multiple Vario appliances:
account space requirement for VV 200 connection strip
between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
(40 mm).
6
3 / " (10 mm).
8
Take into
/ "
9
16

Install Appliance

9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Make a mark exactly in the center of the cut-out.
Fasten the mounting rails to the front and rear edge
of the cut-out. The leading edges of the mounting
rails must lie upon the countertop. The center
marking of the mounting rails must correspond
precisely with the center marking of the cut-out.
Note: For stone countertops, adhere the mounting
rails with temperature-resistant duel-component
adhesive (metal on stone).
2 For combination with the VD 201 appliance cover:
Mount appliance cover to appliance prior to
installation (see VD 201 Installation Instructions).
3 Insert appliance in cut-out. The snap-in pins on the
appliance must lie precisely on the clamp springs.
Press appliance firmly into the cut-out.
pins on the appliance must snap into the clamp
springs.
The snap-in