Stell SHO 2050 Instrucciones Generales De Instalación página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
Note: If the TV is not entirely horizontal after installation on the mount, remove it from the mount (perform the
points from the pictures 6 and 7 in reverse order), repeat the process of levelling and then reinstall the TV set.
Mounting the brackets on the TV set
TV set with fl at rear wall (Fig. 5A)
First, fi nd screws suitable for using to mount the TV set (D/E/F/G): try to screw them manually in the holes
at the back of the TV set. If you feel resistance stop screwing in immediately! Once you fi nd the screw with
the correct threat proceed according to the drawing 5A. Insert matching lock washer on the screw (L/M/
N/O), washer (R/S) and then screw the screw to the bracket B/C and then to the TV. Check that the
brackets are fastened vertically. They are mutually parallel and the locking bolts are facing towards the outer
edge of the TV.
TV set with curved rear wall (Fig. 5B)
First fi nd screws suitable for mounting the TV (H/I/J/K) with a  suitable spacer (P/Q): try to screw
them manually into the holes in the back of the TV. If you feel resistance stop screwing in immediately!
Once you fi nd the screw with the correct threat proceed according to the drawing 5B. Insert matching lock
washer on the screw (L/M/N/O), washer (R/S) and the screw the screw to the bracket B/C, insert
spacers (P/Q) and fi nally, screw them to the TV. When using screws with thread M4 and M5 you will need to
insert between the bracket and the spacer another washer M4/M5 (R). Check that the brackets are fastened
vertically. They are mutually parallel and the locking bolts are facing towards the outer edge of the TV.
Attaching the TV to the bracket and securing with safety bolts
Warning: Handling some TV sets requires help of another person. The manufacturer is not liable for injury or
damage to property caused by improper handling!
First, hook the brackets attached to the TV set (B+C) on the top edge of the body of the holder A, then push
the lower part of the brackets toward the bottom part of the holder (Fig. 6). Then, using Phillips screwdriver,
tighten the locking bolts (Fig. 7).
Congratulation, the installation is done. We wish you a pleasant experience while watching TV mounted on
the wall mount.
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING
Take the used packaging material to the municipal waste disposal.
PRODUCT DISPOSAL AFTER END OF LIFE
Dispose of equipment after the end of life in the designated municipal solid waste place
This product meets all the basic requirements of EU directives that apply to it.
13 – EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sho 2051

Tabla de contenido