Changing Blades (Fig. H, I, J) - DeWalt DCS570 Manual De Instrucciones

English
Worklight (Fig. A)

CAUTION: Do not stare into worklight. Serious eye
injury could result.
15
There is a worklight located just below the blade lock
11
button . The worklight is activated when the trigger
switch is depressed, and will automatically turn off 20
seconds after the trigger switch is released. If the trigger
switch remains depressed, the worklight will remain on.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Trigger Switch (Fig. G)

WARNING: This tool has no provision to lock the
trigger switch in the ON position and should never be
locked ON by any other means.
Release the trigger switch lock-off button
the button as shown. Pull the trigger switch
motor on. Releasing the trigger switch turns the motor off.
Fig. G
1
Changing Blades (Fig. H, I, J)

WARNING: Remove battery from tool before
changing blades.
To Install the Blade (Fig. H, I, J)
1. Retract the lower blade guard
6
retracting lever and place the blade on the saw
spindle against the inner clamp washer, making sure
that the blade will rotate in the proper direction (the
direction of the rotation arrow on the saw blade and the
teeth must point in the same direction as the direction
of rotation arrow on the lower blade guard). Do not
assume that the printing on the blade will always be
facing you when properly installed. When retracting
the lower blade guard to install the blade, check the
condition and operation of the lower blade guard to
assure that it is working properly. Make sure it moves
freely and does not touch the blade or any other part, in
all angles and depths of cut.
2. Place outer clamp washer
large flat surface against the blade with beveled side
facing out.
10
1
by pressing
2
to turn the
2
7
using the lower blade
17
on saw spindle with the
3. Thread blade clamping screw
hand (screw has right-hand threads and must be turned
clockwise to tighten).
4. Depress the blade lock button
saw spindle with the blade wrench (
the blade lock engages and the blade stops rotating.
5. Tighten the blade clamping screw firmly with the
blade wrench.
nOTE: Never engage the blade lock while saw is running,
or engage in an effort to stop the tool. Never turn the saw
on while the blade lock is engaged. Serious damage to your
saw will result.
Fig. H
17
8
Fig. I
6
LOOSEN
(counterclockwise)
7
14
To Replace the Blade (Fig. H, I)
1. To loosen the blade clamping screw
11
blade lock button and turn the saw spindle with the
14
blade wrench until the blade lock engages and the
blade stops rotating. With the blade lock engaged, turn
the blade clamping screw counterclockwise with the
blade wrench (screw has right-hand threads and must
be turned counterclockwise to loosen).
2. Remove the blade clamping screw
17
washer only. Remove old blade.
3. Clean any sawdust that may have accumulated in the
guard or clamp washer area and check the condition
8
into saw spindle by
11
while turning the
14 , Fig. I, J) until
11
TIGHTEN
(clockwise)
8
, depress the
8
and outer clamp