Important Safety Warning - Kicker KXM.1 Serie Manual Del Propietário

MODEL:

IMPORTANT SAFETY WARNING

PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN A DISTORTED, CLIPPED
OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE
AND RESULTING IN SERIOUS DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO
4 INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM)
CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
PERFORMANCE
Model:
RMS Power
@ 14.4V, 4Ω mono, ≤ 1% THD+N
@ 14.4V, 2Ω mono, ≤ 1% THD+N
Length [in, cm]
Height [in, cm]
Width [in, cm]
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Selectable Electronic Crossover
KickEQ+™ Parametric Bass Boost
Subsonic Filter
NOTE: 2017 KXM amplifi er subwoofer channels are 1Ω stable - power rating equivalent to 2Ω operation, +/- 10%
INSTALLATION
Mounting: Choose a dry, structurally sound location to mount your KICKER amplifi er. Make sure there
are no items behind the area where the screws will be driven. Choose a location that allows at least 4"
(10cm) of open ventilation for the amplifi er. Drill four holes using a 7/64" (3mm) bit and use the supplied
#8 screws to mount the amplifi er.
Wiring: The KXM amplifi er's RCA inputs will receive either high or low level signals from your car stereo's
source unit. A high-level signal can be run from the source unit's speaker outputs to the stereo RCA
input on the end panel of the amplifi er using the KICKER KISL as shown. Alternatively, the signal can be
delivered to the amplifi er using the low-level RCA outputs on the source unit. Keep the audio signal cable
away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a
90 degree angle.
2
2017 KXM Mono Amp Rev E.indd 2 2017 KXM Mono Amp Rev E.indd 2
KXM.1-SERIES AMPLIFIERS
OWNER'S MANUAL
KXMA1200.1
KXMA1200.1
600W x 1
1200W x 1
9-9/16,24.4
2 1/8, 5.5
8 5/16, 21
10Hz–160Hz
>95dB, A-weighted, re: rated power
250mV–10V
Variable Lo-pass 40Hz–160Hz, 24dB/octave
Boost - Variable 0–18db; Center Frequency - 20Hz–80Hz; Bandwidth 1–5
Variable 10–80Hz, 24dB/octave
1/16/2017 3:57:16 PM 1/16/2017 3:57:16 PM