Motor Overriding System; Installation Layout - V2 TORQ-D Serie Manual De Instrucciones

3.5 - MOTOR OVERRIDING SYSTEM

m
ATTENTION: before operating the manual release
disconnect the power. The motor is anyway disconnected
during the release, thanks to the presence of a safety
micro-switch.
Manual control has been thought for manual opening of the gate
in case of power-cut or motor breakdown.
1. Operate the manual release moving back the key hole cover.
2. Insert the key in the cylinder lock and turn it of 90° clockwise
direction.
3. Pull the lever till it is perpendicular to the gear-motor.
Automation restore:
1. Bring back the lever in the original position.
2. Insert the key in the cylinder lock and turn it of 90°
anticlockwise direction

3.6 - INSTALLATION LAYOUT

COMPONENTS
Motor
1
2 Transmitter
Receiving module
3
Photocells
4
Flashing light
5
LENGTH OF THE CABLE
Power supply 230V/120V
Photocells (TX)
Photocells (RX)
Key switch
Flashing light
Antenna (integrated into the flashing light)
5
1 3 E
C
ADDITIONAL ACCESSORIES
Key switch
A
B Pillar photocells
Pillar-mounted digital radio switch
C
Safety edges
D
WES-ADI module (via radio management of edges)
E
WES sensors
F
< 10 metres
3G x 1,5 mm
2
2 x 0,5 mm
2
4 x 0,5 mm 2
2 x 0,5 mm 2
2 x 1,5 mm 2
RG174
- 34 -
K
J
4
D
2
from 10 to 20 metres
3G x 1,5 mm
2
2 x 0,5 mm
2
4 x 0,5 mm 2
2 x 0,5 mm 2
2 x 1,5 mm 2
RG174
A
B
from 20 to 30 metres
3G x 2,5 mm
2
2 x 0,5 mm
2
4 x 0,5 mm 2
2 x 0,5 mm 2
2 x 1,5 mm 2
RG174