Transporting - EMAK DS 5300 S Manual De Uso

blade may catch or jerk the clearing saw
forward. This may cause damage to the blade
or loss of control of the clearing saw which
GB
may result in serious injury.
WARNING: A saw blade can only be
used in connection with the proper guard
(see table pag.40) a twin handle and double
harness with release mechanism.
Brush cutting with a saw blade
• Thin stems and brush are mown down. Work
with a sawing movement, swinging sideways.
• Try to cut several stems in a single sawing
movement.
• With groups of hardwood stems, first clear
around the group. Start by cutting the stems
high up around the outside of the group to
avoid jamming. Then cut the stems to the
required height. Now try to reach in with the
blade and cut from the centre of the group. If
it is still difficult to gain access, cut the stems
high up and let them fall. This will reduce the
risk of jamming.

8. TRANSPORTING

TRANSPORTION
Carry the brush cutter with the engine off and
with the protective blade cover on.
ATTENTION: Fit the disk protection before
transporting or storing the brushcutter.
WARNING – When transporting the
machine in a vehicle, ensure that it is properly
secured using belts. The machine should be
transported in a horizontal position with the tank
empty, ensuring compliance with applicable
regulations for transport of such machines.
9. MAINTENANCE
EMISSIONS COMPLIANCE
This engine, including the emissions control
system, must be operated, used and maintained
in accordance with the instructions provided
in the user's manual in order to maintain
34
the emissions performance within the legal
requirements applicable to non-road mobile
machinery.
No deliberate tampering with or misuse of the
engine emissions control system has to take
place.
Incorrect operation, use or maintenance of the
engine or of the non-road mobile machinery
could result in possible malfunctions of the
emissions control system to a point where the
legal requirements applicable are not respected;
in such case a prompt action must be taken in
order to rectify the system's malfunctions and
restore the applicable requirements.
Examples, not exhaustive, of incorrect operation,
use or maintenance are:
- Forcing or breaking the devices for metering
the fuel;
- Use of fuel and/or engine oil not fulfilling the
characteristics shown in the chapter STARTER /
FUELING;
- Use of not original spare parts, for example
spark plug, etc. ;
- Missing or improper maintenance of the
exhaust system, including incorrect timing of
maintenance for muffler, spark plug, air filter,
etc.
WARNING – Tampering with this engine
makes the EU emissions certification no more
valid .
The level of CO of this engine can be found in
2
the Emak's website (www.myemak.com) under
section "The Outdoor Power Equipment World".