Haier GDE560BW Manual Para El Usuario página 24

Eco Dry - Use this cycle to save energy. The program is similar to Normal, but
uses a slightly lower temperature and dries to a slightly lower dry level.
Perm Press - Use this cycle for low-temperature heat and wrinkle-free
fabrics.
Delicate - Use this cycle for extra-low heat to gently dry delicate items.
•
There are 4 Timed Dry Cycles to choose from:
Timed Dry - Use this cycle to run the dryer for a speci c amount of time.
Clothes may be damp or could be over-dried at the end of the cycle.
Quick Dry - Use this cycle to easily select a 20 minute timed cycle for quick
drying a few items.
Touch Up - Use this cycle to easily select a 10 minute timed cycle for
refreshing clean clothes.
Air Dry - Use this cycle to dry foam, rubber, plastic, or heat-sensitive fabrics.
START/PAUSE BUTTON
•
Press this button to start a selected cycle or to pause an operating cycle.
NOTE: After starting a dry cycle, you must pause the dryer to change any of
the options.
NOTE: Opening the dryer door will also pause an operating cycle.
NOTE: If the cycle status is Wrinkle Saver, pressing the pause button or
opening the dryer door will cancel the operating cycle and turn the power
o .
DRY TEMP BUTTON
•
Use this button to select a dryer temperature. For best results, follow your
garment label instructions and use the warmest temperature that is safe for
your fabric.
NOTE: This button works with timed dry cycles only. The No Heat setting is
not available with an automatic cycle.
WRINKLE SAVER BUTTON
•
At the end of the cool down cycle, the dryer will periodically tumble for
1 hour to prevent wrinkles from setting in your garments. Use this button to
extend the feature for 150 minutes or to turn the Wrinkle Saver feature o .
ESTIMATED TIME REMAINING DISPLAY
•
This display shows the estimated total time for a dry cycle in minutes. As the
dryer operates, the minutes will count down to show the time remaining.
•
If the dryer senses a malfunction, an error code will be shown in the display.
Please refer to the "Troubleshooting" section for a list of error codes and
their possible causes and solutions.
TIMED DRY ADJUST BUTTONS
•
Use these buttons to adjust the length of a timed dry cycle. Time can be
adjusted from 10 to 95 in 5 minute increments.
NOTE: If the cycle status is Cool Down, the time cannot be adjusted.
CYCLE SIGNAL BUTTON
•
Use this button to adjust the volume of control panel beeps and the end-of-
cycle signal.
22