Dometic PerfectWall PW3500 Instrucciones De Uso página 46

Adjusting the awning
I
NOTE
To successfully reprogram the wind sensor, the awning must be
extended to the outer limit.
➤ Move the wind sensor (fig. 5 1, page 3) on the inside of the front cover
to the left and take it off.
➤ Release the sensor insert with a screwdriver (fig. 6 A, page 3).
➤ Remove the sensor insert from the housing (fig. 6 B, page 3).
Step 2: Deleting the old sensor
➤ Press the programming button (1) (fig. 3 1, page 2) on the back of the
remote control for 3 seconds.
✓ The awning briefly moves twice.
➤ Press the programming button (2) of the wind sensor (fig. 6 D, page 3)
for 7 seconds.
✓ The awning briefly moves twice. After 6 seconds the awning briefly moves
twice again. The old sensor now is deleted.
Step 3: Programming the sensor
➤ Press the programming button (1) (fig. 3 1, page 2) on the back of the
remote control for 3 seconds.
➤ Press the programming button (2) of the wind sensor (fig. 6 D, page 3)
for 1 second.
✓ The awning moves twice briefly once again. The wind sensor now is
connected.
➤ Test the wind sensor function, see chapter "Testing the wind sensor" on
page 41.
I
NOTE
By repeating step 3 the connection between wind sensor and
awning motor will be deleted again.
46
PW3500
EN