Dometic PerfectWall PW3500 Instrucciones De Uso página 47

PW3500
7.4 Resetting the motor and remote control
The motor and remote control are synchronised by default. The motor and
remote control must be reset in the following cases:
z If the awning no longer responds to the remote control commands
z After changing the motor
Step 1: Check the battery in the remote control
➤ Check that the battery in the remote control is not run down:
To do this, press a button on the remote control.
✓ The LED on the remote control lights up briefly.
If the LED does not light up, the battery is flat. Replace the battery (see
chapter "Changing the battery in the remote control" on page 42).
Step 2: Check the function of the motor and remote control
➤ Check that the motor and remote control work by pressing the
briefly.
✓ The awning extends all the way.
If the awning does not respond, does not extend all the way, extends too
far (fabric is not taut) or stops when the button is released, continue with
step 3.
Step 3: Switch to the programming mode
➤ Switch the awning power supply off and wait 10 seconds.
➤ Switch the power supply on again and wait 10 seconds.
➤ Switch the awning power supply off again and wait 10 seconds.
➤ Switch the power supply on again.
✓ The awning briefly retracts.
I
NOTE
If you don't succeed in starting the programming mode by the pro-
cedure described above, maybe the electronics are already in
programming mode. Try to proceed directly with step 4 "Check the
rotation direction of the motor".
EN
Adjusting the awning
button
47