RIDGID R4513 Manual Del Operador página 29

OPERATION
TO USE THE IND-I-CUT
See Figure 39.
The plastic disc embedded in the saw table in front of the
saw blade is provided for marking the location of the saw
cut (kerf) on the workpiece.
The disc should be level or slightly below the surface of the
saw table. Place a piece of hardwood over the plastic disc
and tap the hardwood with a hammer until the disc is level
or below the saw table surface.
Once the Ind-I-Cut is level:
™
 From the front of the table saw, place the miter gauge
in the left miter groove and move the bevel adjusting
handwheel until the bevel scale is set at 0°.
 Turn on the table saw and cross cut a piece of wood
holding the wood firmly against the miter gauge.
 Turn off the table saw. Once the blade has stopped, pull
the miter gauge back until the freshly cut wood is over
the disc.
 Using a sharp pencil, mark a line on the disc at the edge
of the freshly cut wood.
NOTE: These lines indicate the path of the cut made by
the saw blade. When the blade is changed, these lines
will need to be erased and reset.
 With the miter gauge in the right miter gauge groove,
follow the above procedures and make a second mark
on the disc.
TO SET THE RIP FENCE INDICATOR TO THE
BLADE
See Figure 40.
Use the indicator on the rip fence to position the fence along
the scale on the front rail.
NOTE: The anti-kickback pawls and blade guard assembly
must be removed to perform this adjustment. Reinstall the
blade guard assembly when the adjustment is complete.
 Unplug the saw.
 Place the rip fence on the saw table so that it lightly
touches the right side of the saw blade. Lock the rip fence
in place.
 Loosen pan head screws and adjust the indicator so that
the red line is located over the "zero" line on the right rip
scale on the front rail. Retighten screws.
TO USE THE RIP FENCE
See Figures 41 - 42.
 Loosen the rip fence by lifting the locking lever.
 Place the front of the rip fence on the front rail.
 Lower the back end of the rip fence onto the back rail.
 Check for smooth gliding action.
™
29 − English
IND-I-CUT
INDICATOR
BACK
RAIL
™
Fig. 39
PAN HEAD
SCREW
Fig. 40
BACK OF
RIP FENCE
Fig. 41