Installation - Selco Genesis 3200 GSM Instrucciones De Uso

2.4 Installation

Connection for MMA welding
The connection shown in the figure produces
reverse polarity welding. To obtain straight polar-
ity welding, reserve the connection.
- Connect (3) the earth clamp to the negative socket (-) (4) of
the power source.
- Connect (1) the electrode holder to thpositive socket (+) (2)
of the power source (WF).
Connection for TIG welding
- Connect (4) the earth clamp to the positive socket (+) (3)
ofthe power source.
- Connect the TIG torch coupling (5) to the torch socket (6)
ofthe power source.
- Connect the gas hose from the cylinder to the rear gas con-
nection.
- Connect the signal cable (7) of the torch to the appropriate
connector (8).
- Connect the gas hose (9) of the torch to the appropriate
union/connection (10).
Connection for MIG/MAG welding
- Connect the CAN-BUS signal cable for the control of external
devices (such as RC) to the appropriate connector (11).
- Insert the connector and rotate the ring nut clockwise until
the parts are properly secured.
- Connect the power cable (12) to the appropriate outlet (13).
Insert the plug and turn clockwise until all parts are secured.
- Connect the signal cable (14) to the appropriate connector (15).
Insert the connector and screw the ring nut clockwise until all
parts are secured.
- Connect the gas hose (16) to the pressure reducing valve of
the cylinder or to the gas supply connection (17).
- Connect the water pipe (blue colored
quick connector of the cooling unit.
- Connect the water pipe (red colored
connector of the cooling unit.
- Connect the red colored
inlet quick connector of the cooling unit.
- Connect the blue colored
outlet quick connector of the cooling unit.
- Connect the MIG torch (18) to the central adapter (19), ensur-
ing that the fastening ring is fully tightened.
- Connect (20) the earth clamp to the negative socket (-) (21) of
the power source.
) to the outlet
) to the inlet quick
water pipe of the torch to the
water pipe of the torch to the
39