Preventing Damage; Safety Installations - BDS Maschinen MAB 100 Instrucciones De Manejo

Safety

Preventing damage

Safety installations

Restarting protection
34
CAUTION
Potential damage to property if the machine is improperly
used!
Observe the following instructions to avoid damage:
► Before connecting the machine, compare the connection
data (voltage and frequency) on the rating plate with those
of your mains power supply. The data must correspond in
order to avoid damage to the machine.
► Always use the handle to carry the machine and not the
connecting cable.
► Do not pull the mains cable to remove the plug from the
mains socket.
► Do not crush the connecting cable.
► Do not expose the connecting cable to heat or chemical
liquids.
► Do not pull the connecting cable across sharp edges or hot
surfaces.
► Lay the connecting cable in such a way that it cannot be
caught and wound up in the rotating part of the machine.
NOTE
► The machine stops automatically if the magnetic clamp is
switched off or in the event of a power failure.
In order to prevent unexpected starting of the machine when the
magnetic clamp is switched on again or when the power supply
returns after a power failure ("restarting protection"), the machine
must be switched on at the ON/OFF switch again.
MAB 100