While Operating Machine; Circuit Breakers - Nobles SpeedGleam Manual Del Operador

6. To stop machine, release the triggers. The pad will
automatically raise to the transport position.
7. To transport machine, turn the pad switch off and
pull the triggers. The pad will automatically raise to
the transport position.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.

WHILE OPERATING MACHINE

1. Always operate the machine with caution when
burnishing around walls and obstacles.
2. Always reduce speed to maintain control when
turning.
3. Stay clear of floor obstructions, such as electrical
plates or grates, they will destroy pad. Tilt machine
back to avoid floor obstructions.
NOTE: For safety, when machine is tilted on its rear
wheels, power to the pad motor automatically shuts
off.
4. Change or turn the pads over when worn or soiled.
5. Check the pad pressure meter reading
periodically. Adjust meter within the green zone.
ATTENTION: Do not operate the machine with the
pad pressure meter adjusted in the red zone, floor
damage and brush motor overload will result.
6. Check the battery meter's discharge level
periodically. When the meter's needle drops into
the yellow caution zone, stop burnishing and
recharge the batteries (Figure 16).
ATTENTION: Do not operate machine with the
battery meter in the red zone, battery damage may
result.
FIG. 16
7. If the pad motor circuit breaker should trip, reduce
the pad pressure and/or replace soiled pad (See

CIRCUIT BREAKERS).

Nobles SpeedGleam/Plus (01- 05)
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
WARNING: Fire Or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine in Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
CIRCUIT BREAKERS
The machine is equipped with two resettable circuit
breakers (Main Power- 15A / Pad Motor- 80A) and one
fuse (Control Board- 2A, drive Model) to protect machine
from damage.
If the pad motor circuit breaker should trip, determine
cause, allow motor to cool, then reset. The pad motor
circuit breaker will trip due to excessive pad motor
overload. Change the pad or reduce the pad pressure
if the pad motor circuit breaker should trip.
When replacing the 2A fuse, never substitute a higher
fuse than specified. The Main Power Circuit Breaker and
Control Board Fuse is located at the rear of the control
console. The Pad Motor Circuit Breaker is located under
the battery hood at front of machine (Figure 17).
FIG. 17
OPERATION
11