Battery Charger Specifications; Using The On- Board Battery Charger - Nobles SpeedGleam Manual Del Operador

BATTERY CHARGER SPECIFICATIONS:

S OUTPUT VOLTAGE - 36 VOLTS
S OUTPUT CURRENT - 21 AMPS MAXIMUM
S
AUTOMATIC SHUTOFF CIRCUIT
S
FOR DEEP CYCLE BATTERY CHARGING

USING THE ON- BOARD BATTERY CHARGER

For battery charger operating instructions, refer to
the Battery Charger Manual supplied with charger.
1. Transport machine to a flat, dry surface in a well-
ventilated area for charging.
2. Turn all switches to the OFF position and remove
key if equipped. Set parking brake, if equipped.
3. Unlatch and hinge open both the dust bag hood
and the battery hood to access the battery
compartment.
4. Before charging the batteries, check the
electrolyte level in each battery cell (Figure 21).
The electrolyte level (A) should slightly cover the
battery plates (B). Add distilled water as needed.
DO NOT OVERFILL, the fluid may expand and
overflow while charging. Replace cell caps before
charging (Figure 22).
A
B
Nobles SpeedGleam/Plus (08- 08)
FIG. 21
FIG. 22
5. Connect the charger's AC power supply cord to a
properly grounded receptacle (Figure 23).
6. Flip up hood support stand and rest hood on stand
to promote ventilation (Figure 24).
7. The charger will automatically begin charging and
shut off when fully charged.
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
8. After charging, check the electrolyte level (A)
again. The level should be approximately 1 cm
from the bottom of the fill- port (B) (Figure 25).
Add distilled water if needed. DO NOT OVERFILL.
B
A
OPERATION
FIG. 23
FIG. 24
FIG. 25
13