SATA J Serie Manual Del Uso página 16

Operation guideline:
Caution:
Please read the instruction carefully before operating the machine
Before the use:
1 ） Charging:
This charger and machine shall be used together. Do not use other chargers.
The machine has a protection circuit. When the battery is low, the protection circuit is turned on and the machine stops rotating.
The machine may become hot under the high temperatures or after a long period of operation. At this time, do not charge
immediately but wait until the battery is cooled. Otherwise, the service life of battery will be shortened or the charging failure may
be caused due to overheating.
For the first charging or after a long period of storage, the efficiency of first charging may only reach about 60%. After 2-3 charging
and discharging cycles, the battery efficiency may reach 100%.
2） Installation and removal of battery pack （see Figure A） :
Press the lock buttons on both sides of battery pack and pull it out. To insert the battery pack, simply push it into the machine. Avoid
the excessive force.
Operation:
1 ） Start/stop （see Figure B） :
Press and hold the switch （1） to start the machine, and release it to stop the machine. The switch has the brake function. When the
switch is released, the chuck stops rotating immediately.
Change the force applied to the switch to regulate the rotating speed. The range of adjustment is between 0 and the maximum
rotating speed. The smaller the force is, the lower the rotating speed is. The drilling starts slowly and stably. Prevent the shutdown of
machine due to the excessive load.
Warning:
Do not operate at low speed for a long time. Otherwise the machine will be overheating inside
2） Switch lock （see Figure B） :
The switch has the lock protection function which helps to avoid the accidental activation of the hand drill. Lock the machine by
adjusting the reversing yoke （2） to the center position.
3） Rotation reversing （see Figure B） :
Forward: Push the side of Reversing yoke marked with "
Reverse: Push the side of reversing yoke marked with "
screw.
Warning:
The rotating speed can only be changed after the machine is completely still
4） Speed change （see Figure C）:
Move the shift yoke forwards to the position "1": high torque / low rotating speed for drilling a thicker bit or screwing the screw.
Move the shift yoke backwards to the position "2": low torque / high rotating speed for drilling a thinner bit.
When the mechanical shift lever cannot be toggled due to teeth collision, tap the switch to rotate the motor and then change the
16
51011
中文
EN
" to the end （left side） for drilling a hole and screwing the screw.
" to the end （right side） for releasing or unscrewing the screw the
DE RU KO PT JA ES