Sharp XE-A406 Manual De Instrucciones página 47

Entering character codes with numeric keys on the keyboard
Numerals, letters and symbols are programmable by entering the character code and the
characters entry is selected, "1" is displayed on the operator display (lower line). Press the
it.) Set the alphanumeric character code table on the next page. By doing this, you can program characters
other than those on the key tops.
• Double-size characters can be made by entering the character code 253 or pressing the
displayed when double-size characters entry is selected as shown in the operator display example below.
• All three digits of the character code MUST be entered (even if it starts with zero).
Operator display (Example)
Cursor
Press of
:
253 065 01
Department code, PLU code, UPC code, function number,
clerk code or logo message line number is displayed here.
(UPC code will disappear when
Characters entered are displayed here.
To program the word "SHARP" in double-size characters
253
When you press an appropriate number key (job code number) and press the
start programming with the
PGM
W 065
Character code
: : :
083 072
S H
s
key, the cash register will automatically be ready for text entry.
Characters: Indicating double size character of "A"
Press of
:
H N W
, or is pressed.)
: :
065 082
A R
:
key. (If numeric
N
W
=A PGM
01 W
Number of characters
programmed
:
080
P
P
key for text entry just after you
key to release
key. "W" is
02
45