Parent Unit; Using Your Baby Monitor - Philips SCD589/54 Instrucciones De Manejo

Notes:
– Operation time will be 8 hours based on the assumption that
the baby unit will be transmitting 25% of the time and is in
standby mode for the rest of the time (baby does not any
make sound).
– When the parent unit batteries are charged for the first time,
operating time will be less than 8 hours.The batteries will use
their maximum capacity after at least four times charging and
discharging.
– Charging will take longer than 16 hours when the parent unit
is switched on during charging.To shorten the charging time,
the parent unit should be switched off.
➜ The parent unit is now ready for use!
Use this baby monitor for its intended houshold use as described
in this manual.
1 Place both units in the same room to test the connection. Make
sure the baby unit is at least 1 meter / 3 feet away from the

parent unit.

2 Press and hold the On/Off (y) button (A-1) on the baby unit for 2
seconds.
> The night light (A-10) lights up briefly.
> The display light (A-11) lights up indicating the current room
temperature.
> The LINK light (A-3) lights up red briefly then starts blinking green as
it seeks connection with the parent unit.If, after 30 seconds,no link is
established, O will appear on the display and the
LINK light starts blinking red as it seeks connection with the parent
unit.
3 Press and hold the On/Off button (y) (B-6) on the parent unit for 2
seconds.
> The sound level lights (B-9) briefly light up orange.
> The display (B-8) lights up.The battery indicator (
room temperature light up in the display.
> The LINK light (B-3) lights up red briefly then starts blinking green
as it seeks connection with the baby unit.
> The LINK light (B-3) on the parent unit blinks green and the LINK
light (A-3) on the baby unit blinks red until connection has been
established.This will take up to 30 seconds. Both LINK lights (A-3,
B-3) then light continously green and the message O
will disappear from the baby unit display (A-11).
Preparing your baby monitor

Using your baby monitor

) and the
> 1 m / 3 feet
1m / 3 ft
EN
11