Philips SCD589/54 Instrucciones De Manejo página 5

14 Unplug this product from the wall outlet, discontinue use and return the product to the Philips
Service Location for examination and repair under the following conditions:
A.When the power supply cord or plug is damaged or frayed.
B. If the product has been exposed to rain or water.
C. If the product does not operate normally by following the operating instructions.
D. If the product's cabinet has been damaged.
E. If the product exhibits a distinct change in performance.
15 Do not place this product on an unstable cart, stand or table.The product may fall, causing serious
damage to the product.
16 Make sure the baby unit and adapter cable are always out of reach of the baby
(at least 1 meter / 3 feet away).
17 Never place the baby unit inside the baby's bed or playpen.
18 Never cover the baby monitor (with a towel, blanket, etc.).
If your product utilizes batteries, the following additional precautions should be
observed:
1 Use only the type and size of the battery(ies) specified in the user manual.
2 Do not dispose of the battery(ies) in fire.They may explode. Check with local regulations for
possible special disposal instructions.
3 Exercise care in handling battery(ies) in order not to short out the battery(ies) with conducting
materials such as rings, bracelets and keys. Overcharging, short circuiting, reverse charging,
mutilation, or incineration of the cells and the batteries must be avoided to prevent one or more
of the following occurrences: release of toxic. materials, release of hydrogen and/or oxygen gas, rise
in surface temperature.
4 Do not attempt to recharge the battery(ies) provided with or identified for use with this product
that are not intended to be charged.The battery(ies) may leak corrosive electrolyte or explode.
5 Do not attempt to rejuvenate the battery(ies) provided with or identified for use with this
product by heating them. Sudden release of the battery(ies) electrolyte may occur causing burns or
irritation to eyes or skin.
6 If and when necessary, these cells or batteries must be replaced with identical new ones from the
same manufacturer. If a cell or a battery to be replaced is connected with other cells or batteries
in series, it is recommended that the other cells or batteries be replaced with new ones at the
same time.
7 Reverse polarity installation of the cell or the battery(ies) in the end product must be avoided.
Reverse insertion of battery(ies) can cause charging, and that may result in leakage or explosion.
8 Remove battery(ies) from this product if storing over 30 days because the battery(ies) could leak
and damage the product.
9 Discard 'dead' battery(ies) as soon as possible since 'dead' batteries are more likely to leak in a
product. If a cell or a battery has leaked or vented, it should be replaced immediately using
protective gloves.
10 Do not store this product, or the battery(ies) provided with or identified for use with this product, in
high-temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose of
extending shelf life should be protected from condensation during storage and defrosting. Batteries
should be stabilized at room temperature prior to use after cold storage.
Welcome
EN
5