Power Supply; Measurement Input Terminals; Rs 232 Connector; Tilt Stand - Metrix MX 556 Manual De Instrucciones

2.4.

Power supply

The multimeter is powered directly from the mains either 110 V or 230 V, 50 Hz or 60 Hz.
The mains plug is located at the rear panel of the instrument.
2.5.

Measurement input terminals

Measurements are performed using two measuring leads supplied with the instrument
connected to input terminals 1, 2, 3 and 4, as indicated in § 3.1.
2.6.

RS 232 connector

A serial link - galvanic isolated - enables :
- the multimeter configuration (with SX-ASYC II software)
- the reading - and the printing - of the measured datas
- the re-calibration of the multimeter without removing parts.
The 25 points sub-D connector is located at the rear panel of the instrument.
2.7.

Tilt stand

- Push both latching devices as indicated by the arrows.
- Adjust the handle to position to the required angle.
- Release the latches.
→
30
T x D R x D
• • • • • • • • • • • • •
• • • • • • • • • • • •
GND
Chapter II
←
Benchtop multimeter