Hitachi Koki NT 65M2 Instrucciones Y Manual De Seguridad página 27

Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a Hitachi authorized service center for assistance.
PROBLEM
Nailer operates,
but no nail is driven.
Weak drive.
Slow to cycle.
Drives too deep.
Skipping nails.
Intermittent feed.
Nails jam.
Driven nail is bent.
Drives properly during
normal operation, but does
not drive fully at faster
nailing speeds.
CHECK METHOD
Check for a jam.
Nail feeder damaged?
Ribbon spring weakened
or damaged?
Check for proper nails.
Check air pressure.
Check position of nailing
depth adjuster.
— — — — —
Driver blade worn?
Piston O-ring worm or
damaged?
Check air pressure.
Check position of nailing
depth adjustment guide
plate (A).
Check for proper nails.
— — — — —
Nail feeder damaged?
Ribbon spring weakened or Replace ribbon spring.
damaged?
Piston O-ring worn or
damaged?
Check for proper nails.
— — — — —
Driver blade worn?
Check inside diameter of
air hose.
CORRECTION
Clear a jam page 24.
Replace nail feeder.
Replace ribbon spring.
Use only recommended
nails.
Increase air pressure.
(Do not exceed 120 psi
(8.3 bar 8.5 kgf/cm
Readjust per page 21.
Use Hitachi pneumatic tool
lubricant.
Contact Hitachi for
replacement.
Reduce air pressure.
(Adjust 70 – 120 psi
(4.9 – 8.3bar 5 – 8.5 kgf/cm
Readjust per page 21.
Use only recommended
nails.
Lubricate the nail rail per
page 24.
Replace nail feeder.
Contact Hitachi for
replacement.
Use only recommended
nails.
Lubricate the nail rail per
page 24.
Contact Hitachi for
replacement.
Use larger air hose.
English
2
))
2
))
27