Janome 1110DX Manual De Instrucciones página 39

3
7
6
4,5,6,7
9
8
8,9,10,11
12
3
4
A
5
7
10
38
3. Hold the thread at both ends and tug gently to ensure
the thread is correctly inserted between the tension
discs. (If the presser foot lifter is raised, the thread
easily inserts between the tension discs.)
3 Lower looper thread tension dial
4. Hook the thread on the corner A , and then pass
the thread through the looper thread guide.
4 Looper thread guide
5. Pass the thread through changeable thread guide.
6. Pass the thread through the looper thread
take-up lever (lower).
7. Pass the thread through lower looper thread
guide (1).
5 Changeable thread guide
6 Looper thread take-up lever (lower)
7 Lower looper thread guide (1)
8. Then lift up the lower looper thread guide (1) to its
threading position. When you do this, the other lower
looper thread guides (2) and (3) will automatically move
up to make it easier to reach them.
8 Lower looper thread guide (2)
9 Lower looper thread guide (3)
9. Pass the thread through the lower looper thread guide (2).
10.Pass the thread through the lower looper thread guide (3).
11.Holding the end of the thread, push the lower looper
thread guide (1) down with your other hand to return it to
its original position.
At the same time, lower looper thread guides (2) and (3)
will return to their original positions. You can also return
the lower looper thread guides (1), (2) and (3) to their
original positions by turning the handwheel counterclock
wise.
12.Move the lower looper to its rightmost position by
turning the handwheel, and drag the thread with a pair
of tweezers through the hole on the lower looper 4˝
(10 cm) or more.
10 Lower looper