Commissioning; Connecting The Test Leads; Switching On The Instrument; Switching Off The Instrument - Metrix MX 58HD Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Chapter II
3.

COMMISSIONING

3.1.

Connecting the test leads

Connect the black lead to the COM socket (for all measurements). Depending on the position of
the selector switch, connect the red lead as follows:
Rotary selector switch position
V
, mV
, V
AC
DC
10 A
DC
5 mA
, 50 mA
DC
3.2.

Switching on the instrument

Turn the selector switch to the required function.
All segments of the display come on for a few seconds. The instrument is then ready for
measurements.
3.3.

Switching off the instrument

The instrument can be switched off manually by returning the selector switch to the OFF
position, or automatically after approximately half an hour if no key is pressed or the switch is not
operated.
Note
Automatic shutdown of the instrument is disabled in order to avoid
interrupting the peak value measurements (Pk +/-), or the data print out.
For user safety, automatic shutdown is also disabled when a measured
magnitude (voltage/current) present at the input exceeds dangerous level
(
indicator displayed).
3.4.

Special configurations

To adapt the configuration of the instrument to the measurement environment, the user can
choose 50 Hz or 60 Hz rejection :
Switch on with the rotary switch while holding down the HOLD key.
The selection :
is reversed from the last configuration
is displayed for two seconds
remains backed up in non-volatile memory.
Portable digital multimeter
, Ω,
DC
, 500 mA
DC
DC
Input terminal
10 A
500 mA
21

Publicidad

Tabla de contenido
loading

Tabla de contenido