Fein 7 129 Serie Manual De Instrucciones página 16

OBJ_BUCH-0000000213-001.book Page 16 Wednesday, August 12, 2015 8:19 AM
en
16
Symbol, character Explanation
Low oscillation rate
High oscillation rate
(**) may contain numbers and letters
Character Unit of measurement,
international
U
V
f
Hz
n /min, min
S
r/min
°
kg
kg
kg
L dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
hand-guided power tool for use in weather-protected
environments without water supply, using the application
tools and accessories recommended by FEIN:
Automotive
– for cutting polyurethane beads for glazier work in
automobiles, lorries and busses
– for sawing out chassis sections and removing under-
seal materials
– for sanding of chassis parts
Unit of measurement,
national
V
Hz
-1
, rpm, /min
°
kg
kg
kg
dB
dB
dB
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
Explanation
DC voltage
Frequency
Rated oscillation rate
Oscillation angle
Weight according to EPTA-Procedure 01
Weight of the power tool without battery and
application tool
Weight of the battery
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to
EN 60745 (vector sum of three directions)
Basic and derived units of measurement from
the international system of units SI.
Construction
– for sawing wood, plastic, glass-fibre reinforced plas-
tics (GFRP) and for sawing sheet metal (max. 1 mm)
– for removing tile joints and rasping or scraping off tile
grout or carpet remainders
– for sanding or rasping of smaller surfaces.
Special safety instructions.
Hold the power tool by the insulated gripping surfaces
when performing operations where the application tool
could contact hidden wires. Contact with a "live" wire
will also make exposed metal parts of the power tool
"live" and shock the operator.
Use clamps or another practical way to secure and sup-
port the workpiece to a stable platform. Holding the
work by hand or against your body leaves it unstable and
may lead to loss of control.
Grasp the power tool in such a safe manner that your
body never comes into contact with the application tool,
especially while working with application tools such as
saw blades or other blades pointed toward the grasping
range. Touching sharp tips or cutting edges can lead to
injuries.