Greencut GRI300XM Manual De Instrucciones página 63

ENGINE OIL
The engine of your machine comes from the factory without oil for transport reasons. Before starting the engine for
the first time, oil must be added to the engine. This engine uses quality oil for 4-stroke engines.
FILLING THE OIL TANK
1. Place the machine on a flat, horizontal, unobstructed surface.
2. Unscrew the oil filler cap.
3. Enter the indicated quantity of oil through the filler hole. Wait 1 minute for the oil to flow completely into
the engine crankcase.
4. Clean the dipstick of the oil plug with a cloth.
5. Insert the dipstick without screwing in the oil plug.
6. Remove the plug and check the mark that the oil has left on the dipstick. The signal left by the oil must be
close to or at the maximum mark.
7. If the mark is below the minimum, add a little more oil and check again.
8. Once inserted, screw on the oil filler cap.
STARTING AND STOPPING THE ENGINE
CHECK POINTS BEFORE COMMISSIONING
Do not use this machine if it is damaged or incorrectly adjusted. Check the machine:
• Look for loose parts (screws, nuts, etc.) and damage.
• No fuel leaks.
• That the oil and fuel level is correct.
• That the air filter is clean. Clean the filter if necessary.
Tighten, repair or replace as necessary before using the machine. Do not use any accessories on this machine other
than those recommended as their use could cause serious injury to the user, the machine, people, animals, and things
near the machine.
POSITIONING OF THE MACHINE
Make sure you install the machine in a stable position. Connect a wire from the generator ground to ground.
START
ENGINE START
1. Turn the fuel tap to "ON".
2. Set the Economic Control Switch (ECS) to "OFF".
3. Set the power switch to "ON".
4. Pull the choke lever out in the "closed" position.
NOTE: When the engine is hot, to start the engine, put the choke directly in the "open" position,
that is, with the lever inwards.
5. Pull the recoil starter slowly until it engages, then pull it tightly. If the engine does not start in several
attempts, move the choke to the "open" position and pull the recoil starter.
NOTE: Hold the carrying handle securely to prevent the generator from falling when pulling the
recoil starter.
6. After starting the engine, warm it up until it does not stop when the choke lever moves to the "open"(
position.
63
EN
)