Safety Instructions When Using Long Drill Bits; Additional Safety Warnings - Bosch PS130 Instrucciones De Funcionamiento Y Seguridad

2610056735 02-21 PS130_BM 2610015935 02-12.qxp 2/15/21 10:23 AM Page 5
Do not use dull or damaged bits and
n.
accessories. Dull or damaged bits
have a greater tendency to bind in the
workpiece.
When removing the bit from the tool
o.
avoid contact with skin and use
proper protective gloves when
grasping the bit or accessory.
Accessories may be hot after prolonged
use.
Check to see that keys and adjusting
p.
wrenches are removed from the drill
before switching the tool "ON". Keys
or wrenches can fly away at high
velocity striking you or a bystander.
q. Do not run the tool while carrying it at
your side. A spinning drill bit could
become entangled with clothing and
injury may result.
GFCI and personal protection devices like
electrician's rubber gloves and footwear
will further enhance your personal safety.
Do not use AC only rated tools with a DC
power supply. While the tool may appear
to work, the electrical components of the
AC rated tool are likely to fail and create a
hazard to the operator.
Keep handles dry, clean and free from oil
and grease. Slippery hands cannot safely
control the power tool.
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be
careful not to disassemble any portion of
the tool since internal wires may be
misplaced or pinched or safety guard
return springs may be improperly
mounted. Certain cleaning agents such as
gasoline, carbon tetrachloride, ammonia,
etc. may damage plastic parts.
Ensure the switch is in the off position
before inserting battery pack. Inserting
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and
(3) product using battery.
Use only the charger which accompanied

Additional Safety Warnings

Battery/Charger
Before using battery
charger, read
Safety instructions when using
long drill bits
a. Never operate at higher speed than the
maximum speed rating of the drill bit.
At higher speeds, the bit is likely to
bend if allowed to rotate freely without
contacting the workpiece, resulting in
personal injury.
b. Always start drilling at low speed and
with the bit tip in contact with the
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece,
resulting in personal injury.
c. Apply pressure only in direct line with
the bit and do not apply excessive
pressure. Bits can bend causing
breakage or loss of control, resulting in
personal injury.
the battery pack into power tools that
have the switch on invites accidents.
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with
equipment, such as those dust masks that
are specially designed to filter out
microscopic particles.
your product or direct replacement as
all listed in the catalog or this manual. Do
not substitute any other charger. Use only
Bosch approved chargers with your
product. See Functional Description and
Specifications.
-5-
Some dust created by
power sanding, sawing,
approved safety