Blackstone 1517 El Manual Del Propietario página 7

Model 1517 | Owner's Manual | Assembly Guide
S T E P 0 4 With the help of another person
Insert the side shelf into the slots on the griddle body. Secure the shelf with
two (2) small thumbscrews.
S T E P 0 5
right side of the griddle body by
inserting four (4) M6x12 bolts from
the outside of the body and then
secure them with four (4) flange
nuts from the inside of the body.
Use a screw driver and a wrench
to tighten.
S T E P 0 6
10
, place the griddle unit upright.
Install handle to the
Install the control knobs by pushing them into place.
BAT TERY POWERED IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignition button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
CLEANING THE GRIDDLE COOKING SURFACE
S T E P 0 7
With the help of another person , place the griddle top onto the
minutes and repeat the lighting procedure. If this does not work, to deter-
griddle body by aligning the four pins to the holes on top of the body. Make
mine the cause, please try to ignite your griddle with a match. (Please
sure the pins are fully seated in the holes. Place the grease cup on the back of
S T E P 0 1
reference the Match Lighting Instructions in the Cleaning the Burner
the griddle body in the center of the unit.
Assembly section of the Care & Maintenance chapter.) each use, cool griddle below 300° F.
Scrape food debris with spatula or
straight metal scraper.
If you CAN ignite your griddle with a match
S T E P 0 2
POSSIBLE CAUSES SOLUTION
surface with paper towel.
01. Dead battery or no battery. Replace with new battery.
02. Battery installed incorrectly. Ensure that the battery is installed nega-
tive end first.
S T E P 0 3
03. Igniter wire misaligned. Ensure that the igniter wire is posi-
tioned 1/8" to 1/4" away from the burner
into approximately 6" sections
tube, positioned above a burner hole.
(width of scraper tool). Apply a
small amount of water onto first
S T E P 0 8
Connect the 20lb propane tank (not included). (Please reference
04. Damage to the ignition system. Contact customer service for replace-
section with a bottle and then
ment parts.
the Connection & Removal section of the Fuel | Propane – 20lb. Tank chapter.)
scrape the water and debris toward
the grease trap. Move to the next 6"
If you CAN NOT ignite your griddle with a match
S T E P 0 9 Proceed to the Griddle Seasoning Instructions section of the
section and repeat.
Care & Maintenance chapter. Enjoy cooking outdoors on your Blackstone 28"
POSSIBLE CAUSES SOLUTION
Cooking Station! DO NOT USE MORE THAN TWO
TABLESPOONS OF WATER
05. Burner tubes are not Please reference the Gas Flow section of
receiving propane. AT A TIME. the Troubleshooting Chapter.
1/4 cup of table salt may be used to
buff off stuck food residue.
S T E P 0 4
paper towel and dry completely.
S T E P 0 5
cooking oil to maintain seasoning
and protect the griddle top.
Care & Maintenance Assembly Guide | Owner's Manual | Model 1517
!
WA R N I N G
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A
HOT GRIDDLE AT ONCE.
This may cause warping.
To clean griddle after
!
C A U T I O N
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy
the griddle's seasoning.
Wipe down griddle
Divide griddle surface
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
Wipe again with a
NEED HELP? Register your Blackstone
product at blackstoneproducts.com/
pages/register-product and contact
Blackstone Customer Service for missing
parts, assembly and operation questions:
 PHONE:
435-252-3030 ext 1
Apply thin coat of
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/pages/
customer-support
11