Blackstone 1836 El Manual Del Propietario página 7

Model 1836 | Owner's Manual | Assembly Guide
S T E P 0 4
shelf on the griddle body by sliding
it in place and tightening two (2)
of the small thumb screws to lock
it in place.
S T E P 0 5
Screws to install the handle to the
griddle body.
S T E P 0 6
install the second side shelf and handle.
10
Install the right side
Use four (4) M6x12
Repeat the previous two steps on the left side of the griddle to
BAT TERY POWERED IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignition button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
CLEANING THE GRIDDLE COOKING SURFACE
S T E P 0 7
Place the grease cup on
minutes and repeat the lighting procedure. If this does not work, to deter-
the back of the griddle body in the
mine the cause, please try to ignite your griddle with a match. (Please
center of the unit.
S T E P 0 1
reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.) each use, cool griddle below 300° F.
Scrape food debris with spatula or
straight metal scraper.
If you CAN ignite your griddle with a match
S T E P 0 2
POSSIBLE CAUSES SOLUTION
surface with paper towel.
01. Dead battery or no battery. Replace with new battery.
S T E P 0 8 With the help of another
02. Battery installed incorrectly. Ensure that the battery is installed nega-
person , place the griddle top onto
tive end first.
the griddle body by aligning the four
S T E P 0 3
03. Igniter wire misaligned. Ensure that the igniter wire is posi-
pins to the holes on top of the body.
tioned 1/8" to 1/4" away from the burner
into approximately 6" sections
Make sure the pins are fully seated
tube, positioned above a burner hole.
(width of scraper tool). Apply a
in the holes.
small amount of water onto first
04. Damage to the ignition system. Contact customer service for replace-
section with a bottle and then
S T E P 0 9
Connect the 20lb
ment parts.
scrape the water and debris toward
propane tank (not included).
the grease trap. Move to the next 6"
(Please reference thve Connection
If you CAN NOT ignite your griddle with a match
section and repeat.
& Removal section of the Fuel |
Propane – 20lb. Tank chapter.)
POSSIBLE CAUSES SOLUTION
DO NOT USE MORE THAN TWO
TABLESPOONS OF WATER
05. Burner tubes are not Please reference the Gas Flow section of
receiving propane. AT A TIME. the Troubleshooting Chapter.
1/4 cup of table salt may be used to
S T E P 1 0 Proceed to the Griddle Seasoning Instructions section of the
buff off stuck food residue.
Care & Maintenance chapter. Enjoy cooking outdoors on your Blackstone 36"
Griddle Cooking Station!
S T E P 0 4
paper towel and dry completely.
S T E P 0 5
cooking oil to maintain seasoning
and protect the griddle top.
Care & Maintenance Assembly Guide | Owner's Manual | Model 1836
!
WA R N I N G
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A
HOT GRIDDLE AT ONCE.
This may cause warping.
To clean griddle after
!
C A U T I O N
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy
the griddle's seasoning.
Wipe down griddle
Divide griddle surface
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
Wipe again with a
NEED HELP? Register your Blackstone
product at blackstoneproducts.com/
pages/register-product and contact
Blackstone Customer Service for missing
parts, assembly and operation questions:
 PHONE:
435-252-3030 ext 1
Apply thin coat of
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/pages/
customer-support
11