Environmental Protection - Triton MOF 001 Instrucciones De Uso

SYMBOLS

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Always wear ear, eye and respiratory
protection.
Conforms to relevant legislation
and safety standards.
FUNCTIONS
POWER SWITCH
When the router is connected to the power source, the
Power Switch (11) will illuminate in both 'On' and 'Off'
positions.
The Retracting Power Switch Cover (12) prevents
accidental starting of the router. It must be retracted
before the router can be switched on. The cover will
remain open until the router is switched off.
CUT DEPTH ADJUSTMENT
There are three methods of cut depth adjustment,
depending on the accuracy and control required: Free
Plunge, for conventional and fast depth adjustment; Table
eight Winder, for controlled and fast adjustment; and
Micro Adjuster, for precise depth setting throughout the
full plunge range.
FREE PLUNGE
1. Free plunge depth
adjustments can be made
with the Plunge Selection
GB
Button (5) engaged. Press it
deep inside the handle until
it engages inward.
2. Release the Plunge Lock Lever (15) and push the body
of the router until the required depth is reached. Re-
lock the plunge lock lever
3. The position of the plunge lock lever can be altered
by removing its retaining screw and repositioning the
lever on the bolt. Re-tighten firmly.
Symbols / Functions
6
MOF001_23/04/13.indd 6
Instruction warning.
Double insulated for additional protection.
TABLE HEIGHT WINDER
1. Table height winder plunge depth adjustments can be
made when the Plunge Selection Button (5) is flush
with the handle. If engaged, press the plunge selection
button inward and allow it to spring out flush with the
handle. Ensure the Plunge
Lock Lever (15) is unlocked.
2. Pull the Winder Handle
Clutch Ring (4) into the
handle then turn the handle
to raise or lower the cutter.
Release the ring at the
required depth, allowing it to
'pop out', locking the cutter at the required depth.
3. Lock the plunge lock lever, particularly for heavy cuts.
MICRO WINDER
For use in Table Height
Winder plunge mode only.
1. Disengage the Plunge
Selection Button (5), and
ensure that the Plunge Lock
Lever (15) is unlocked.
If the Micro Winder (2) is turned with the plunge lock
lever engaged, the micro winder will start clicking and
the cut depth will remain unchanged.
2. Turn the micro winder
clockwise to increase cut
depth and anti-clockwise to
reduce cut depth.
27/08/2014 10:39