Stihl FC 95 Manual De Instrucciones página 17

4
5
50 mm
( 2" )
Fit the square nut (4) in the loop
N
handle, insert the clamp screw (5)
from the other side and tighten it
down firmly.
Lining up the loop handle
Line up the loop handle and move it
N
to the most comfortable position.
Loosen the screw (5).
N
Move the loop handle along the
N
drive tube as required – tighten
down the screw firmly.
Version B
Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
FC 95, FC 110
Lining up the loop handle
1
Use the combination wrench to
N
loosen the screw (1).
Turn the handle to the vertical
N
position.
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
Slide the handle to the required
N
position.
Tighten down the screw with the
N
combination wrench so that the
handle cannot be rotated on the
drive tube.
English
15