Ignition | Piezo-Electric; Troubleshooting - Blackstone 1666 Manual Del Propietário

Model 1666 | Owner's Manual |

Ignition | Piezo-Electric

IGNITION |
!
WA R N I N G
PIEZO -ELECTRIC
Do not lean over griddle
while lighting.
GRIDDLE OPERATING INSTRUCTIONS
For proper ignition and operation of the griddle follow the steps below.
!
WA R N I N G
If ignition does NOT occur in 5
seconds, turn burner controls
OFF, wait 5 minutes and repeat
lighting procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner and could
accidentally/inadvertently ignite
with risk of injury.
If ignition does NOT occur in 5 seconds, turn burner control OFF, wait 5
minutes and repeat lighting procedure.
For additional support, see youtube.com/blackstonegriddles
20
S T E P 0 1
Make sure LP tank is
properly connected to unit. Turn
gas ON at LP cylinder by taking 20
seconds to turn knob halfway.
S T E P 0 2
Push in control knob to
start gas flowing, then turn control
knob counter-clockwise to acti-
vate starter.
S T E P 0 3
Adjust temperature to
desired level.

TROUBLESHOOTING

Section 01
PIEZO-ELECTRIC IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not ignite with piezo ignition system
To determine the cause, please try to ignite your griddle with a match.
(Please reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
01. Igniter wire misaligned. Ensure that the igniter wire is positioned
1/8" to 1/4" away from the burner tube,
positioned above a burner hole.
02. Damage to the ignition system. Contact customer service for replace-
ment parts.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
03. Burner tubes are not Please reference the Gas Flow section of
receiving propane. the Troubleshooting Chapter.
Troubleshooting | Owner's Manual | Model 1666
21