Tungsten Carbide Cutters; Abrasive Points - Dremel 8200 Instrucciones De Funcionamiento Y Seguridad

DM 2610007240 08-09:DM 2610007240 08-09 8/21/09 1:11 PM Page 21
Note: Each number settings listed in the speed charts = 000 RPM's
Catalog
Number Wood
9901, 9902, 25-30
9903, 9904,
9905, 9906,
9909, 9910,
9911, 9912
Catalog
Number Wood
612, 640 25-30*
615, 617, 618, 25-30*
650, 652, 654 25-30*
Catalog
Number Wood
83142, 83322,
83702, 84922,
85422, 85602,
85622
Catalog
Number Wood
516, 517,
518
500
Catalog
Number Wood
541,903, 911, 25-30
921, 932, 941,
945, 952, 953,
954, 971, 997,
8153, 8175,
8193, 8215
Speed Settings (Continued)
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.

Tungsten Carbide Cutters

Soft Hard Laminates
Wood /Plastic
18-24 9-11
High Speed Router Bits
Soft Hard Laminates
Wood /Plastic
18-24 • -
25-30 • -
18-24 • -
Silicon Carbide Grinding Stones
Soft Hard Laminates
Wood /Plastic
- - 12-17

Abrasive Points

Soft Hard Laminates
Wood /Plastic
9-17 9-17 -
9-17 9-17 -
Aluminum oxide grinding stones
Soft Hard Laminates
Wood /Plastic
25-30 -
Steel Aluminum,
Brass, etc.
25-30 12-17
Steel Aluminum,
Brass, etc. Stone
- -
- -
- -
Steel Aluminum,
Brass, etc. Stone
25-30 9-11
Steel Aluminum,
Brass, etc. Stone
18-24 12-17
12-24 9-17
Steel Aluminum, Shell/
Brass, etc. Stone
18-24 9-11 12-17
21
Shell/ Ceramic Glass
Stone
18-24 18-30 18-30
Shell/ Ceramic Glass
- - -
- - -
- - -
Shell/ Ceramic Glass
12-17 25-30 25-30
Shell/ Ceramic Glass
- - -
- - -
Ceramic Glass
25-30 -