Dyna-Glo DGA480SSN Manual Del Usuario página 12

ASSEMBLY INSTRUCTIONS
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 11.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
11. Open the lid and place the four heat tents (X)
on the brackets directly above the burners.
12. Place cooking grates (Y) on the grill body
braces and grill rear panel, then insert the
warming rack (W) into the 2 holes located
on the back edge of the grill body (O).
13. Insert the grease pan (S) into position by
sliding it in the grill body (O) from the rear
along the rails located just below the
underside of the grill body (O). Insert the
grease cup (T) into position by sliding it onto
the rails located on the bottom side of the
grease pan (S).
11
VALVE
ORIFICE
12
13
12
O
Y
O
T
X
W
S