Troubleshooting - Magic Vac Genius Instrucciones De Uso

The MAGIC VAC does not work
®
• Make sure the MAGIC VAC
properly. Check the electric socket by plugging
another appliance into it.
• The MAGIC VAC will stop automatically if over-
®
heated. Allow it to cool down for 15 minutes and
try again.
• Check for faults in the power cord or the plug.
Should you detect a fault, do not use the appli-
ance.
The MAGIC VAC fails to apply the first seal on
®
the bag cut from the roll
• Make sure the bag cut from the roll is prop-
erly positioned as described in the paragraph:
"Making bags from MAGIC VAC
The MAGIC VAC does not create a complete
®
vacuum in the bags
• To seal the bag properly, you must make sure
that the open end remains completely inside the
Vacuum Chamber.
• Make sure that the Sealing Bar, the Sealing
Gaskets and Airtight Gaskets are free of impuri-
ties. After cleaning them, put them properly back
in place.
• The MAGIC VAC bag might have a hole in it.
®
To check the bag, seal it with air inside, place it
underwater and apply pressure on it. The appear-
ance of bubbles means that there is a leak. Reseal
or use another bag.
The MAGIC VAC does not seal the bag properly
®
• If the Sealing Bar overheats and melts the bag,
you may have to raise the Lid and allow the
Sealing Bar to cool down for a few minutes.
• The MAGIC VAC is built in conformity with cur-
®
rent safety standards. Overheating will cause it
to turn off automatically. Allow the appliance to
cool down for 15 minutes and try again.
The MAGIC VAC bag does not maintain a vacu-
®
um after being sealed
• Leaks along the seam may be caused by creases,
crumbs, grease or liquids. Reopen the bag, clean
the upper inside part of the bag and remove
any foreign material from the Sealing Bar before
resealing it.
• Check that the bag has no holes in it which have
caused air to leak in. Use paper napkins to pro-
tect any sharp edges on the contents of the bag.

TROUBLESHOOTING

has been plugged in
®
rolls"
®
21
The MAGIC VAC does not create a vacuum in the
®
containers
• By means of the Connection Hose, connect the
container lid (or the Cap Attachment if necessary)
to the Air Inlet of the appliance.
• Leave enough room (at least 3 cm) between the
contents and the top of the jar or container.
• If liquids come out during the vacuum-packing
process, remember that they must first be chilled
in a refrigerator, not left at room temperature.
• Check that the rim of the jar or container and
the universal lid are not damaged in the sealing
area. Wipe the rim and cap clean with a cloth
moistened with lukewarm water and repeat the
vacuum-packing process.
• Make sure that the gasket of the container cap
or the universal cap is set properly in place and is
not damaged.
MAGIC VAC Executive containers or MAGIC VAC
®
Universal Caps do not maintain a vacuum
• Make sure that the arrow on the knob of the
container cap is positioned on "VACUUM" before
creating a vacuum in the container and it is posi-
tioned on "CLOSED" after a vacuum is formed.
• Make sure that the O-ring beneath the knob of
the container cap or the universal cap is set prop-
erly in place.
MAGIC VAC Family containers do not maintain a
®
vacuum
• Make sure that the gasket beneath the central
button (14) of the container cap is set properly in
place.
®