GE GFD40 Manual Del Propietário página 11

REVERSING THE DOOR SWING (if desired)
REMOVE DOOR ASSEMBLY
1
A. Open the door to approximately 130 degrees.
B. Remove 4 screws starting from the bottom to
the top. Make sure the door is supported while
removing the screws.
Remove
C. Loosen the top screw as shown. Unhook the
door by lifting and pulling. Remove screw.
Top Screw
D. Place the door on a soft protected flat surface
so the inner door faces upward (door resting
on handle side). Remove the 6 tapping screws
located around the perimeter of the door outlining
the gasket and the 2 hinge cover tapping screws.
Remove the 2 hinge machine screws and the 4
innermost door machine screws.
6 - # 10
Tapping
Screws
2 - # 8
Machine
Screws
49-90584
Optional Instructions
2 - # 10
Tapping
Screws
4 - # 8
Machine
Screws
2 REMOVE HINGE AND COVER
IMPORTANT: Note the location of the hinge (left
or right) before removing.
• With the screws removed, turn the door over
and separate the outer door assembly and hinge
cover of the door from the door frame and set
aside.
Outer Door Assembly
Hinge Assembly
REINSTALL HINGE ASSEMBLY
3
A. Install the hinge assembly in the opposite
side of the door as shown. Push the hinge
assembly in place until the hinge holes align
with the door holes.
B. Hold the hinge and door on their side with one
hand and fasten the 2 machine screws as shown.
Hinge Cover
Machine
screws
11