GE GFD40 Manual Del Propietário página 6

Getting started
A
Dry Cycles
B
The dry cycle controls the length and tumble speed of the drying process. The chart below will help you match
the dry setting with the loads.
Sensor Cycles
Mixed Loads
Cottons
Delicates
Speed Dry
Dewrinkle
Time Cycle
Air Fluff/
No Heat
C
D
E
6
Power
Press to "wake up" the display. If the display is active, press to turn the dryer off.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Description
For loads consisting of cottons and poly-blends.
For cottons and most linens. NOTE: Energy Star
default settings.
For lingerie and special-care fabrics.
For small loads that are needed in a hurry, such as sports or school uniforms. Can also be
used if the previous cycle left some items damp, such as collars or waistbands.
Provides 20 minutes of drying to assist with dewrinkling items that are dry or slightly
damp. This cycle is not recommended for delicate fabrics.
Description
Provides 10 minutes of tumbling time without heat.
Time Dry
Use to set your own dry time. Time Dry is also recommended for small loads. To use:
1. Turn dry cycle dial to Time Dry.
2. Increase the drying time by pressing the Time Dry button.
NOTE: This button only increases the time. When max time is reached, pressing the button
again will reset the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Start/Pause.
Temp (Temperature)
You can change the temperature of your dry cycle.
High For regular to heavy cottons.
Medium For synthetics, blends and items labeled Permanent Press.
Low For delicates, synthetics and items labeled Tumble Dry Low.
Extra Low For lingerie and special-care fabrics.
Level
The sensor continuously monitors the amount of moisture in the load. When the moisture in
your clothes reaches your selected dry level, the dryer will stop.
NOTE: Sensor dry Level only works with Mixed Loads, Cottons, Delicates, Speed Dry
and Dewrinkle cycles.
More Dry Use for heavy-duty fabrics or items that should be very dry, such as towels.
Dry Use for normal dryness level suitable for most loads. This is the preferred
cycle for energy saving.
Less Dry Use for lighter fabric (ideal for ironing).
Damp For leaving items partially damp.
® models are tested on Cottons with
49-90584