GE GFD40 Manual Del Propietário página 12

REVERSING THE DOOR SWING (if desired)
REINSTALL HINGE COVER
4
A. Insert the hinge cover. Align the hinge cover
holes with the holes in the door.
Hinge
Cover
2 - # 10
Tapping
Screws
B. Secure the hinge cover with 2 tapping screws.
5 MOVE STRIKE BRACKET
A. Using a putty knife or any other flat tool, remove
the 5 beauty buttons located on the dryer where
the door will be installed and install them on the
opposite side.
Beauty
Buttons
B. Switch the strike bracket and its cover to
the opposite side by removing the screws.
Reinstall both on the opposite side.
Tapping
Screws
12
Optional Instructions
REASSEMBLE DOOR ASSEMBLY
6
IMPORTANT: Make sure there is no dirt or any
other foreign material in between the window panes.
A. Place the plastic outer door onto the inner door.
Make sure that the handle part of the outer door
is opposite the hinge as shown.
Outer Door
Inner Door
B. Turn the door over and fasten the outer door
to the inner door using the 6 tapping screws
and the 4 machine screws.
6 - # 10
Tapping
Screws
REINSTALL DOOR ASSEMBLY
7
• The door is now ready to be installed on
the dryer. To ease this step, the hinge has
keyholes that allow a partially fastened screw
to be used as a hook.
Partially fasten a screw to the uppermost screw
hole. Hook the door on the partially fastened
screw.
Fasten the hinge by installing the other 4
screws and tightening the partially fastened
screw above.
Partially
Inserted
Screw
Tighten
All
Screws
4 - # 8
Machine
Screws
49-90584