Installing The Belt Hook - Bostitch SMART POINT BTFP71917 Manual De Operación Y De Mantenimiento

IN AddITION TO THE OTHER WARNINGS CONTAINEd IN THIS
MANuAL OBSERvE THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval from
BOSTITCH.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or contact trip in an actuated position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not continue to use a tool that leaks air or does not function properly. Notify your nearest
BOSTITCH representative if your tool continues to experience functional problems.

INSTALLING THE BELT HOOK

Always disconnect tool from air supply before making adjustments or before attempting
any part assembly or disassembly.
Always remove the belt hook from the tool when selecting Contact Trip Mode.
1. Assure that the sequential trip mode is selected
2. Squeeze the sides of the belt hook body
3. Align the post on the belt hook body with the alignment hole and push into position
4. Release the sides of the belt hook body and check to ensure that the belt hook is locked in position
1
uSING THE INTEGRATEd PENCIL SHARPENER
A standard pencil sharpener is integrated into the belt hook for the operator's convenience. To sharpen a
pencil, insert any standard pencil into the hole and rotate the pencil to the right (clockwise)to sharpen.
2
3
-10-
4