Bostitch SMART POINT BTFP71917 Manual De Operación Y De Mantenimiento página 14

MAINTENANCE CHECKLIST
Maintenance
Inspect trigger performance
Drain condensation from air
compressor tanks and air
filters daily or after each use.
Clean magazine assembly
Clean nose, door, and
contact arm area
Ensure all fasteners remain
tight
Check/clean air inlet air filter
Replace no-mar tip
Replace piston/driver
assembly
Replace O-rings
Replace bumper
Replace headvalve
Replace engine cylinder
Benefit
Ensure trigger system is in
proper working order
Prevents accumlation of
moisture that can impede tool
performace
Prevents accumlation of
debris that could cause a jam
Prevents accumulation of
debris that could cause a jam
or malfunction
Prevent loose parts
Maintains proper air flow to
engine for peak performance.
Prevents marks in softwood
applications
Maintains consistent drive
quality
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Procedure
Refer to Tool Operation
Check section in this manual
Open drain cock on tanks
and air filters and drain all
condensate
Blow clean with compressed air
Blow clean with compressed air
Tighten all fasteners with
appropriately sized hex
wrench
Remove end cap and use
compressed air blow gun to
blow filter clean. Replace filter
as required.
Remove worn no-mar tip and
replace with a new tip (a spare tip
is located on the magazine)
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
-14-
Service Interval
Daily
Daily
Daily
Daily
Weekly
25,000 Fasteners, or monthly
- if used in dusty location
25,000 Fasteners
150,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
500,000 Fasteners