Instructions For Assembly; List Of Spare Parts - Kettler Unix P Instrucciones De Montaje

GB
Please ensure that liquids or perspiration never enter the ma-
■
chine or the electronics.
The equipment is dependent of revolutions per minute.
■
A slight production of noise at the bearing of the centrifugal
■
mass is due to the construction and has no negative effect upon
operation. Possibly occurring noise during reverse pedalling re-

Instructions for Assembly

Ensure that you have received all the parts required (see check
■
list) and that they are undamaged. Should you have any cause
for complaint, please contact your KETTLER dealer.
Before assembling the equipment, study the drawings carefully
■
and carry out the operations in the order shown by the dia-
grams. The correct sequence is given in capital letters.
Please note that there is always a danger of injury when wor-
■
king with tools or doing manual work. Therefore please be ca-
reful when assembling this machine.
Ensure that your working area is free of possible sources of dan-
■
ger, for example don't leave any tools lying around. Always
dispose packaging material in such a way that it may not cau-
se any danger. There is always a risk of suffocation if children
play with plastic bags!
The equipment must be assembled with due care by an adult
■
List of spare parts page 32-34
When ordering spare parts, always state the full article number,
spare-partnumber, the quantity required and the S/N of the pro-
duct (see handling).
Example order: Art. no. 07652-000 / spare-part no. 94318311
/ 2 pieces / S/N ....................
Please keep original packaging of this article, so that it may be
used for transport at a later date, if necessary.
Goods may only be returned after prior arrangement and in (in-
ternal) packaging, which is safe for transportation, in the original
box if possible.
It is important to provide a detailed defect description / damage
report!
Important: spare part prices do not include fastening material; if
fastening material (bolts, nuts, washers etc.) is required, this
should be clearly stated on the order by adding the words „with
fastening material".
sult from engineering and are absolutely safe.
The crosstrainer has a magnetic brake system.
■
To operate correctly, the pulse function requires a minimum vol-
■
tage of 2,7 volts (only for computers working with batteries).
Before beginning your first training session, familiarize yourself
■
thoroughly with all the functions and settings of the unit.
person. If in doubt call upon the help of a second person, if
possible technically talented.
The fastening material required for each assembly step is sho-
■
wn in the diagram inset. Use the fastening material exactly as
instructed. The required tools are supplied with the equipment.
Bolt all the parts together loosely at first, and check that they
■
have been assembled correctly. Tighten the locknuts by hand
until resistance is felt, then use spanner to finally tighten nuts
completely against resistance (locking device). Then check that
all screw connections have been tightened firmly. Attention:
once locknuts have been unscrewed they no longer function
correctly (the locking device is destroyed), and must be repla-
ced.
For technical reasons, we reserve the right to carry out prelimi-
■
nary assembly work (e.g. addition of tubing plugs).
Waste Disposal
KETTLER products are recyclable. At the end of its
useful life please dispose of this article correctly and
safely (local refuse sites).
KETTLER GB Ltd.
GB
Kettler House, Merse Road
North Moons Moat
Redditch, Worcestershire B98 9HL
+44 1527 591901
www.kettler.co.uk
USA KETTLER International Inc.
1355 London Bridge Road
Virginia Beach, VA 23453
www.kettlerusa.com
+44 1527 62423
Mail: sales@kettler.co.uk
+1 888 253 8853
+1 888 222 9333
5