Welding - AXXAIR SAXX-210 Instrucciones Originales

INNOVATIVE ORBITAL SOLUTIONS
Some machines can be directly used as AXXAIR
machines but somes machines require a calibration.
At the first use of competitor machine, go to menu
"Welding" and "MANU". If there is not a button
« Start calibration », the machine can be used
directly. If there is a button "start calibration" check
that the machine can rotate freely and press « start".
When the button "stop" disseapears, the calibration
is completed and the head can be used normally.
Calibration is saved and it is not necessary to do it at
each use. However, it can be necessary to do it
again, for example when using machine with
adjustable resistance, if the setting of the resistance
has been modified or if another machine of same
reference but with different setting of resistance is
used. Also in case of software updating, it can be necessary to do it again.

4.7. Welding :

Manual torch
mode
To move
manually
machine and
wire
Start/stop manually the cooling unit.
Indicator shows if flow is detected or not.
Join experience
Start and stop manually the gas so as to check if
bottle is open and connector well connected. If a flow
is detected, green indicator is illuminated.
The torch gas stops automatically after 90s (unless a
cycle has been started meanwhile), which is not the
case of the internal gas. A liter counter allows you to
know how much internal gas has been sent since the
activation of the line. This counter is reset as soon as
the line is deactivated. If the internal gas has been
activated manually before a welding cycle, it will be
stopped at the end of the cycle if the program
manages the gas flow, otherwise not. In all cases, the
gas flow alarms are active if the gas is sent.
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 67 -
To weld with a
program.
To freely modify
parameters during
welding (not
accessible to
operator).
To test rotation of
program.
After selected one of
these functions, you
have to choose the
program you want to
use.