AXXAIR SAXX-210 Instrucciones Originales página 72

INNOVATIVE ORBITAL SOLUTIONS
Screens during welding :
Available if « operator dynamic » value is different of zero: to modify paraleters during
welding
Switch to downslope
Operator dynamic :
Welding end:
Pressing the STOP
downslope causes rapid downslope in 2s.
Join experience
Time chart to see welding progress
When cycle is finished, you can to choose to return at
button during
the starting position (this is done automatically with
closed head, except if there is an alarm). With SATO,
you can use machine buttons: Y for yes and N for no.
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
You can see
measured values.
- High pulse information
- Low pulse information
- Angle (negative if right rotation)
- Speed
To stop immediately the welding (switch to
postgas) and activate the alarm « 0A: ALL
STOP ».
Choose on the left the parameter you
want to modify. Then press + or – buttons
to modify the value.
On the bottom left, you can see the
maximum percentage allowed of the
programmed value.
If the wire speed is displayed and your
machine has left and right buttons, then
the left button act as a push on the button
- and pressing the right button act as a
press on the + button for the wire speed.
Return to starting position:
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 72 -
English
programmed and